14358816
Located in Visalia, CA
Pay: $25.20/hr - $28.88/hr
Job Full Description
Electronic Tech II
Position Description
This position reports to the Test Area Supervisor. This position will perform test setups, fixture design, fixture construction, product failure analysis, test data analysis, and perform production test duties.
Qualifications
Electronic Tech II position requires that the candidate meet the minimum entry requirements of the position and have achieved the maximum wage range as a Tech I. Appointment to Tech II position may be considered prior to achieving the highest wage range if the individual has a A.S. degree in electronics and/or achieved advanced training in a related field and meets the minimum entry requirements of the position.
Minimum Requirements
- Must have achieved the maximum wage available for Electronic Tech I.
- Must demonstrate ability to diagnose typical failure conditions for rectifier assemblies, multipliers, and power supplies.
- Must demonstrate ability to accumulate test data and accurately communicate the data to assembly supervision and engineering.
- Must demonstrate ability to accurately set up test equipment for production test.
- Must demonstrate ability to produce test fixtures for new products.
- Must work effectively and efficiently with limited or no supervision.
- Must demonstrate cooperation with co-workers and supervision.
- Must have achieved an average performance review rating of 4.0 minimum for the previous 2 review periods.
- Must have no rating of less than 3 on any category in the past 2 review periods.
Duties and Responsibilities
Work Assignments. Work assignments will be directed by the Test Area Supervisor and will require performing production test duties as well as special project support.
Production Test. Most work will involve setup and test of high voltage diodes, rectifier assemblies, multipliers, and power supplies. This position requires accurate testing. Accuracy is critical and impacts highly sensitive customer applications. Attention to detail is vital.
Read Technical Drawings/Schematics. Will be frequently required to read electrical schematics, prepare proper test setup, perform required electrical testing.
Test Equipment. Extensive use of oscilloscopes, volt meters, current meters, and various other test equipment is required. This position requires thorough knowledge of required equipment.
Failure Analysis. Products that do not conform to required specification will be tested and a thorough diagnosis will be supplied to VMI engineering and production supervision. Written reports may be required.
Test Fixture Design. Products may require use of non-standard equipment or test fixtures. This position will assigned special projects that require analysis of need and construction of fixtures to meet the requirement.
Test Data Analysis. Products require review of test data for detection of trends that may indicate a potential for future non-conformance. This position will review test data and report accurate information to production supervisor and engineering. Written reports may be required.
Visalia, CA
2433
4002 South Demaree
Visalia, CA 93277
Apply Now Email Us